APOX G – 33 is a rigid set , high quality cement – based adhesive suitable for most types of vitrified , ceramic wall and floor tiles including natural of regular size APOX G -33  is also suitable for renovation of interior floor and walls.

• Apply the mixed adhesive to the prepared substrate using the appropriate notched trowel for the
• Size of the tile being laid. A minimum of 3mm bed thickness for walls and floors must be
• Achieved. Ensure the bedded tiles are fully supported by the adhesive with no voids
• Underneath or behind. Lay tiles into the adhesive before it skins. The adhesive may also need to
• Be applied to the back of the tiles to accommodate the required levels. Do not disturb tiles until
• The adhesive has dried. Commence grouting after 24 hours when tile work is firm.

• Height Strength bond
• No odour
• Economical
• Easy to spread
• Interior use for wall and floor
• Thick & thin bed application

20kg  APOX G - 33 powder requires approximately 5 to 5.5 ltr of water per bag . add pre _

Measured water to a clean mixing container and sprinkle APOX G -33 powder slowly into the

Liquid with constant stirring. Eliminate lumps. Mix to thick toothpaste consistency. Allow to

Stand for two minutes. Then remix. The adhesive is now ready to use.

The above information and details herein and based on the test conducted and experience on applications and usage. The user is advised to carry out the test and take trials to satisfy on the suitability of the product and meeting his requirements considering the prevailing conditions prior to apply/using it on large area. As the conditions under which the product are used for transported are beyond our control. We would not hold ourselves responsible on its consequential non performance.